Zvárací prístroj FUJIKURA 22S

Požiadať o cenovú ponuku

Fujikura 22S je najmenšia a najľahšia zváračka v triede s aktívnym nastavením vlákien. Ideálna pre použitie v FTTH aj v najneprístupnejších miestach. Množstvo programov na zváranie SM,MM,DS,NZDS vlákien vrátane použitia konektorov FuseConnect. Multifunkčný kufor, dlhá výdrž batérie a kvalitný nepoškriabateľný 4,73″ LCD.

 

Prezentácia Fujikura 22S

Popis

Cladding dia. / Sheath dia.125 μm / Up to 3mm with sheath clamp
Cleave length5mm to 16mm
Splice mode / heating modeTotal 100 splice modes / 30 heating modes
Splice loss0.03dB (SM), 0.01dB (MM), 0.05dB (DS) and 0.05dB (NZDS)
Measured by cut-back method relevant to ITU-T and IEC standards.
Splice timeTypical 9sec SM FAST, Typical 11sec SM AUTO
Tube heating timeTypical 24sec FP-03,coating dia.250μm
Typical 25sec FP-03,coating dia.900μm
Typical 19sec Slim 60mm ,coating dia.250μm
Typical 16sec Slim 40mm ,coating dia.250μm
Splice result storageLast 10,000 splices
Viewing methods / magnification2 axis CMOS camera with 4.73” color LCD.
132X magnification, 200X magnification after splicing
Tension test1.96 to 2.25N
Applicable protection sleeve60mm, 40mm and Fujikura micro sleeves
No. of splice / heating per battery full chargeTypical 200 cycles with BTR-11
Electrode life5000 splices
Size / weight120W x 189D x 72H (mm) / 1140g (including battery)
Operating conditionAltitude : 0 to 5,000m above sea level, Wind : 15m/sec
Temperature : -10 to 50deg C, Humidity : 0 to 95%RH, non-dew
Resistance featuresShock : 76cm (30inch) bottom surface drop
Dust : Exposure to dust (0.1 to 500μm dia Alumina Silicate)
Rain : H=10mm/hr for 10min
Other featuresPC software upgrade / data management

 

 

Parametre Fujikura 22S
Parametre Fujikura 22S
Fuji22S_E.pdf
1.0 MiB
513 Downloads
Detaily